 issue I've never encountered
I am hoping someone can help me out. I have contacted EquipmenttZone and hopefully will be in contact with Javier tomorrow.
I have a T3 and after replacing the capping station everything was working fine. As part of my normal maintenance I replaced the two printhead ribbon cables as they were about 6 months old.
The ribbon cables I replaced had no visible signs of the typical black "hot spot" or anything out of the ordinary. If anything they were at most a little hazed over and a little worn but nothing major I could detect. After installing the new ones and powering everything back up I had no movement in the bed or the carriage. The only thing I did notice on power up is the pass counter flashes a quick "7" and than just the power light is on.
I checked the board for the typical blown fuses but could not detect anything, I also rechecked to make sure all the ribbon cables were properly inserted and in the right locations. I even went as far as trying a spare print head I keep on hand.
Whether I push the ink button, eject, or pass buttons all I get is the clicking noise. Once the machines switch is on and I hit the power button i can no longer shut the machine off using the button almost like its in a frozen state.
Any assistance or help would be appreciated as I can not detect anything to my knowledge out of place or abnormal.
Any Ideas?? Once again, on power up, I get no movement out of anything?? | 
Re: issue I've never encountered 
