TheAtomicSoul

Hi folks,

After searching the internet and finding no helpfull information on the subject I got lucky and found this forumn; I hope someone here might now how to get this setup.

I work with DecoStudio and a Barudan 15 stitch machine. I was only trained a small amount on how to do things, and for normal sewing I am good enough. Right now however someone wants a raised look to an item, and that means using a foam sheet under the image to get it to poof up.

The woman who did this before me did it, but I only saw the final result of them. She left suddenly and I can't figure how to get it to cut through the foam without leaving peices sticking out of the end.
The thread count would be too much to just increase the count ot make it work that way; anyone know what could be done?

Any help is well appreciated!
The Atomic Soul

 

Reply With Quote

vctradingcubao

Welcome to the forums, TAS. There's a bit of a discussion about 3D foam embroidery here:
Can someone please walk me through 3D embroidery
although I must admit that some questions still remains. I use a Pulse DG/ML software and I'm also having problems with this 3D embroidery that I ended up asking another digitizer to do it for me.

__________________
www.busyPrinting.com
Heat Transfer Paper Price List

 

Reply With Quote