 Tee shirt sublimation tips needed
I am a little new to sublimation and have an order for 15 shirts. I am using a white polyester shirt that is textured slightly but kind of thin. The first one that I did came out ok, but when I re-used the teflon pillow to do the other side, apparently the ink was still on it a little and it ended up transferring the back image onto the front of the garment. I also seem to be getting the paper marks around the edges. I have the vapor foam, but it doesn't seem to be helping that much. I have read the instructions from Conde, but I figure someone out here has to have a proven way of doing these that they can share. Should I use a paper towel in between the layers on top of the teflon pillow? I am currently using an air press heat press on super light pressure and heating about 390 for 45 seconds. Any and all advice is appreciated. | 
