th31d10t

I have just recently purchased the supplies I needed to create mugs. Sometime I have problems with getting the graphics to transfer completely. Normally my problem occurs closest to the mug handle. Here are a couple pictures from a few that I have done already though.

 

Reply With Quote

lindsayanng

You should take ap icture of the metal one with out a flash.. turn up the ISO and put it on macro and get a good pic of the graphics. Its hard to tell, but it looks like on the metal one there are some white spots on the front.

The red white and blue one looks AWESOEM to me though..

 

Reply With Quote

th31d10t

The lil white spots on teh front are from where I dropped it right after taking it out of the press. It really made me mad but it was just a test so I was okay. I will try that though to get a better picture of it. Thanks for the tip.

 

Reply With Quote

Teeser

I have to keep the graphic about a thumb's width away from the handle on either side. If you need to get close to the handle you may want to invest in mug wraps which cover a little better. I prefer my mug press so I just shrink the image down.

 

Reply With Quote