macx

Hello, I'm from The Netherlands and looking for a garment printer.

Tomorrow I'm gonna watch a second hand DTG Kiosk Printer, low priced. It is known that the printhead needs replacing and the printer is not used for a while.

Does someone have tips or suggestions where to look at this printer? Typical problems beside the printhead.

Tnx!

Cees

 

Reply With Quote

equipmentzone1

Cees,

If the printer hasn't been used in a while, you will have to replace the printhead and capping station. In my experience, it's unlikely that the bulk ink system was fully flushed before the Kiosk was put in storage, so you will most likely have to install a new bulk ink system as well.

Are you getting any sort of warranty with this printer? You do want to make sure that the printer turns on and can load and unload with no issues. Also make sure that RIP software is included with your printer, as that can be expensive.

Best regards,

Alex

__________________
EquipmentZone.com • Veloci-Jet XL Printer • SpeedTreater Automatic Pretreater
DuPont Ink Master Distributor • Fast T-Jet DTG Printer Parts - Supplies - Tech Support

 

Reply With Quote

macx

Tnx Alex. The price is $2.8k. Prices I've seen on the Internet are much higher. There is no guarantee but they assured me the printer is only not used for a while.
Loading, unloading I'll check and the rip and accessoires must include with the printer.

Update:
Bought the DTG. The printer was in good shape with accessoires and ink.
Quite simple machine, i don't understand that they are that expensive.

 

Reply With Quote