wearstheink

Its the weekend and I just realized I'm out of cleaning solution for my Anajet. I have a job to finish by morning and the head is gunked. What is safe to use? What is the cleaning solution made of anyhow??? I'm wanting to soak the print head for a few hours...any suggestions?
thanks

 

Reply With Quote

zoom_monster

Warm distilled water while not as aggressive as the real stuff works well. How are you planning on soaking? If you're real "gunked" you may want to backflush the lines and clean out the dampers. if you run the water through the lines ( don't get water in the carts) and clean out any over accumulation of pigment in the dampers, you can most likely get away without anything drastic.

__________________
imprimeo! ....Digitizing, DTG and Embroidery..FREE Embroidery SOFTWARE
Sierra Consultant, Stitch ERA Universal Dealer, Digitizing trainer for GUNOLD USA

 

Reply With Quote

wearstheink

thank you so much for the quick reply. I will try the warm distilled water and cross my fingers. I hate doing anything much more than than.

 

Reply With Quote

zoom_monster

Quote: Originally Posted by wearstheink thank you so much for the quick reply. I will try the warm distilled water and cross my fingers. I hate doing anything much more than than.

Are all the channels firing? just a bad nozzle check?

__________________
imprimeo! ....Digitizing, DTG and Embroidery..FREE Embroidery SOFTWARE
Sierra Consultant, Stitch ERA Universal Dealer, Digitizing trainer for GUNOLD USA

 

Reply With Quote