systmvayne

I was looking for help on how to line up a two location print. the platten is not large enough to fit the entire image in one print. so i was hoping to be able to do it in two. the black squares represent the different locations. Any help would be great!

 

Reply With Quote

zoom_monster

Should not be a problem. May take a little brainwork to figure out, but registration is not super critical here so it should be fairly easy. On getting close to the collar and seams, it helps to be able to raise the shirt on some foam cut to allow the collar and any high spots to get down below any head strikes and still be able to get the shirt as close to the head as possible for a good clean print.

Attached Images

photo[1].jpg (41.9 KB, 27 views)

 

Reply With Quote